Input Selection; Direct Operation - Sanyo PLC-ZM5000 Owner's Manual

Input Selection

Direct Operation

Side Control/Remote Control Operation
Remote Control
Side Control
*
INPUT button
INPUT button*
* Only the Input button function is set Mode 1 in the Setting menu, the INPUT button is used for
switching input source. (p.51)
The input source changes each time you press the INPUT button on the side control or the remote
control as follows:
Before using the INPUT button on the side control or the remote control, you must select a correct
input source by On-Screen Menu and the latest input source will be displayed.
Remote Control Operation
Press the INPUT 1, INPUT 2, or INPUT 3 button on the remote control. The input source appears on
the screen as you press each button. Select the connected input source.
INPUT 1 button INPUT 2 button
Input 1 Input 2
Remote Control
RGB (PC analog)
Video
RGB (Scart)
Y,Pb/Cb,Pr/Cr
INPUT 1/2/3 buttons
RGB
RGB (PC digital)
RGB (AV HDCP)
HDMI
INPUT 3 button
Input 3
Video
Y,Pb/Cb,Pr/Cr
S-video
33