Chicago Electric 91222 Assembly And Operating Instructions Manual page 8

When unpacking, check to make sure the following parts are included. All sizes listed below are approximate.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual. Refer to parts diagram at end of manual.
Warning:
There are certain applications for which this tool was designed. Harbor Freight Tools strongly recom-
mends that this tool not be modified and/or used for any application other than which it was designed.
All accessories must be rated for at least the RPM speed recommended on the tool's warning
label. Wheels and other accessories running over rated speed can fly apart and cause injury.
For safest operation, it is recommended that only these accessories be used with this product:
Abrasive Cut-Off Discs and Wheels
Wire Brushes
Always use an approved and proper guard when using the above mentioned accessories. Each
accessory must have the correct arbor size and must fit properly on the shoulder bushing.
Make sure accessories are tightened down securely.
CAUTION: NEVER INSTALL A CARBIDE TIPPED OR STEEL CIRCULAR SAW
BLADE FOR USE ON THIS ANGLE GRINDER. NEVER INSTALL A
WOOD CARVING BLADE, CARVING DISC WITH SAW CHAIN
CUTTERS, OR A CUTTING CARVING DISC ON THIS ANGLE GRINDER.
SKU 91222
SYMBOLOGY
V ~
A
n o xxxx/min.
Item #
N/A
29
28
2
N/A
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
Volts Alternating Current
Amperes
No Load Revolutions
per Minute (RPM)
UNPACKING
Description
Grinder
Side Handle
Wrench
Grinding Wheel
Spare Brushes
Flap Wheels
Wire Wheel Brushes
Qty.
1
1
1
1
2
Page 8