G Erase; Erase - Sharp AR-C172M Operation Manual

Erase

The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 10 mm (1/2") in it's initial
setting.
Original
1 Touch the [ERASE] key on the SPECIAL
MODES screen.
ERASE
COVERS
2 Select the desired erase mode.
ERASE
EDGE CENTRE EDGE+CENTRE
ERASE ERASE ERASE
3 Adjust the amount of erase and touch the
[OK] key.
CANCEL OK
EDGE
(0 20)
10
mm
Copy
The erase setting screen
will appear.
The erase icon ( ) will
also appear in the upper
left of the screen to
T
indicate that the function
is turned on.
Select one of the three
erase modes. The
selected key will be
highlighted.
Use the and keys
to adjust the erase width
and then touch the [OK]
key.
EDGE ERASE
Eliminates shadow lines around the edges of
copies caused when heavy paper or a book is used
as an original.
CENTRE ERASE
Eliminates shadow lines produced by the bindings
of bound documents.
EDGE + CENTRE ERASE
Eliminates shadow lines around the edges of
copies and eliminates the shadow at the centre of
copies.
4 Touch the [OK] key on the SPECIAL
MODES screen.
Return to the main screen of copy mode.
About the steps that follow
If a reversing single pass feeder is being used,
see pages 5-2 through 5-6. If the document
glass is being used, see pages 5-7 through 5-9.
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen.
SPECIAL MODES
6
6-5