Sharp AR-C172M Operation Manual page 6

INSTALLATION REQUIREMENTS
Improper installation may damage this product. Please note the following during initial installation and whenever the
machine is moved.
1. The machine should be installed near an accessible
power outlet for easy connection.
2. Be sure to connect the power cord only to a power
outlet that meets the specified voltage and current
requirements. Also make certain the outlet is
properly grounded.
G For the power supply requirements, see the
name plate on the main unit.
3. Do not install your machine in areas that are:
G damp, humid, or very dusty
G exposed to direct sunlight
G poorly ventilated
G subject to extreme temperature or humidity
changes, e.g., near an air conditioner or heater.
4. Be sure to allow the required space around the
machine for servicing and proper ventilation.
A small amount of ozone is produced within the copier during operation. The emission level is insufficient to cause
any health hazard.
NOTE:
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
weighted average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier
in a ventilated area.
0-2
(11-13/16")
80cm
(31-1/2")
(23-5/8")
3 ) calculated as an 8 hr. time-
30cm
60cm
(23-5/8")
60cm