Job Memory - Sharp AR-250 Operation Manual

JOB MEMORY

Frequently used job programs can be stored in one of nine storage
registers. This is convenient for quick job recall without losing time
manually reprogramming each aspect of the job.
All functions that can be set in the copy mode except the copy
quantity setting can be stored in the job memory.
If any function which has been stored in a job program is modified
by a key operator program, the key operator settings will supercede
the previous setting.
KEY OPERATOR Job memory replacement/deletion can be
prohibited. See page 8-24.
8 9
LEAR
PROGRAM
0
P
RECALL
STORE/DELETE
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL STORE/DELETE
MAKE COPIER SELECTIONS AND PRESS
[OK].
1. A4
2. A3
AUTO AUTO A4
EXPOSURE PAPER SELECT
2-18
Storing a job program
Press the PROGRAM (
1
CLEAR
C
Press the "STORE/DELETE" key on the touch panel.
2
Select a program number from 1 to 9 on the touch panel.
3
EXIT
Make all copier selections to be stored.
4
OK
CANCEL
Press the "OK" key to complete the storage.
5
100%
COPY RATIO
The JOB PROGRAMS screen will appear on the touch panel.
To cancel the job memory mode, press the "EXIT" key or the
CLEAR ALL ( ) key.
CA
The numbers which are highlighted are program numbers which
have been used.
If a program number which has been used is entered, a message
will appear to confirm the selection. To replace with the new
program, press the "STORE" key and proceed to the next step.
To cancel replacement, press the "CANCEL" key.
) key.
P