Copying From The Document Glass - Sharp AR-250 Operation Manual

INTERRUPT CLEAR ALL
CA
START
CLEAR
C
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
AUTO
AUTO A4
EXPOSURE PAPER SELECT
Original size detector
Centring scale

COPYING FROM THE DOCUMENT GLASS

Press the START (
5
If the copier is in the GROUP mode (the sort icon is not displayed
on the touch panel), copying will start and the number in the copy
quantity display will decrease by 1 each time a copy is made. To
repeat the same copy sequence with a different original, simply
replace the original and press the START (
If the copier is in the SORT mode, the original will be scanned
when the START (
Proceed to step 6.
To cancel a copy run, press the CLEAR ALL (
will stop and the number in the copy quantity display will be reset
to 0.
3
Remove the first original with the next original after the
6
START (
START (
have been scanned. Then, press the "READ-END" key
READ-END
on the touch panel.
Copying will start after the "READ-END" key is pressed.
100%
COPY RATIO
2-sided copies from 1-sided originals
To copy in the 1-sided to 2-sided copy mode, an optional duplex module
(AR-DU1) must be installed.
Set the last page of the document onto the document
1
glass, using the centring scale to position it.
NOTE:
Do not place objects under the original size detector, because they
may damage it.
Close the document cover.
2
The original size will be indicated on the touch panel, and the paper
tray with the corresponding paper size will be automatically selected.
Press the 2-SIDED COPY key.
3
AUTO
) key.
) key is pressed but copying will not begin.
) key indicator lights up, and then press the
) key. Repeat this step until all the originals
) key.
) key. Copying
CA
2-9