Touch Panel (Basic Screen) - Sharp AR-250 Operation Manual

Touch Panel (Basic screen)

CUSTOM SETTINGS (
Press to set key operator programs or adjust the
contrast of the touch panel.
2-SIDED COPY key
Press to select the 1-sided to 1-sided, 1-sided to
2-sided*, 2-sided to 1-sided* or 2-sided to 2-
sided* copy mode.
* To select the 1-sided to 2-sided or 2-sided to 2-
sided copy mode, an optional duplex module
(AR-DU1) must be installed. To select the 2-
sided to 1-sided or 2-sided to 2-sided copy
mode, an optional RADF must be installed.
OUTPUT key
Press to select the finisher mode: SORT or
GROUP.
EXPOSURE display
Indicates the selected exposure mode.
EXPOSURE key (p. 2-16)
Press to select the exposure mode: AUTO,
TEXT, TEXT/PHOTO, or PHOTO.
PAPER SELECT display
Displays the selected paper size. When "AUTO"
is displayed, paper size matching the original and
copy ratio will be automatically selected.
PAPER SELECT key
Press to select the desired paper tray.
READY TO COPY.
1. A4
2. A3
AUTO AUTO A4
EXPOSURE PAPER SELECT
) key
PART NAMES AND FUNCTIONS
ORIGINAL A4
A4R
100%
COPY RATIO
COPY RATIO display
Displays the copy ratios for reductions or
enlargements.
COPY RATIO key
Press to select a reduction or enlargement copy
ratio or select the automatic copy ratio selection
mode.
REVIEW ( ) key
Press to check the settings of selected functions.
Initial settings
The copier assumes the initial settings when the
CLEAR ALL ( ) key is pressed and approximately 1
CA
minute after the last copy is made in any mode.
Except for the paper tray selection, the copier also
assumes the initial setting when it is turned on.
Copy ratio: 100%
Automatic exposure
Copy quantity: 0
All special copier modes are set to off.
Tray select: Paper tray 1 (At power on, the
previously selected tray will again be selected.)
Optional large capacity tray will be selected when
installed.
KEY OPERATOR Initial settings can be
programmed as desired. The auto clear time can also
be changed. See pages 8-17 and 8-21.
6-5