Job Program Memory; G Storing A Job Program; Storing A Job Program - Sharp AR-C262M Operation Manual

JOB PROGRAM MEMORY

Frequently used job programs can be stored in each of ten storage registers. This is convenient for quick job recall
without losing time manually reprogramming each aspect of a job. Job programs can be recalled with ease, and the
programs are retained even when the power is turned off. By programming frequently used copy settings, you can
eliminate the bother of selecting the settings each time you use them for a copy job.
GSelection for functions stored as part of a job program, will not be recalled as part of the program if the function has
been disabled or changed by a key operator program.
GTo exit the job memory mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on the
touch panel.

Storing a job program

1 Press the [#/P] key.
2 Touch the [STORE/DELETE] key to obtain
the storage register screen.
M NUMBER.
RECALL STORE/DELETE
Touch a number key from 1 to 10 on the
3
storage register screen.
PROGRAMS
ESS PROGRAM NUMBER.
RECALL STORE/
4 Make all copier selections to be stored.
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
SPECIAL MODES
2-SIDED COPY
A4
DUPLEX
OUTPUT
A4
A3
Highlighted storage
register numbers are
registers which already
have programs stored.
The number of copies
cannot be stored.
PLA
B
5 Touch the [OK] key.
AND PRESS
CANCEL OK
NCEL].
AUTO
ORIGINAL
AUTO
PLAIN
EXPOSURE
B5
AUTO A4
A4
PAPER SELECT
DUPLEX
A4
100 %
A3
COPY RATIO
If a number key is selected in step 3 that has
already been programmed.
A setting confirmation screen will appear. To
replace the existing program with the new
program, touch the [STORE] key and continue
from step 4. If you do not wish to replace the
existing program, touch the [CANCEL] key to
return to the screen of step 3 and select a different
number key.
NOTE
If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to storing a job program. (See page 16 of the
key operator's guide.)
The selected settings
will be stored under the
register number
selected in step 3.
6-25
6