Messages And Signals - Sharp UX-P520 Operation Manual

Messages and Signals

Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see page 56 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
COVER OPEN
CHECK PAPER SIZE
DOCUMENT JAMMED
FAX RX IN MEMORY
FILM END
FUNCTION MODE
74
Check the printing paper. If the tray is empty, add
paper and then press
tray, make sure it is inserted correctly (take out the
stack, align the edges evenly, and then reinsert it in
the tray) and then press
The cover (operation panel) is open. Press down
firmly on both sides of the cover to close it.
An incorrect size of paper may have been loaded in
the paper tray. Check the size of the loaded paper (if
needed, remove the paper and load A4-size paper).
STOP
Press to clear the message.
The original document is jammed. See the following
section, Clearing Paper Jams . Document jams will
occur if you load more than 10 pages at once or load
documents that are too thick (see page 25).
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The imaging film may need replacement. Check the
film and replace if necessary.
has been pressed.
START/MEMORY
. If there is paper in the
START/MEMORY
.