Sending A Fax From Memory - Sharp UX-P520 Operation Manual

Sending a Fax From Memory

Sending a Fax From Memory
You can scan a document into the fax's memory and send the document from
memory. This increases transmission speed and allows you to send a fax to
multiple destinations in a single operation. After transmission, the document is
automatically cleared from memory.
Broadcasting (sending a fax to multiple destinations)
This function allows you to send the same fax to as many as 20 different
locations in just one operation.
♦
When sending to multiple locations, only auto-dial numbers can be used to
dial the numbers of the receiving machines.
1
Load the document(s).
•
If desired, press
resolution and/or contrast.
2
START/MEMORY
Press
3
Press
(if no name was stored, the number will appear).
4
Press
5
Repeat Steps 3 and 4 for each of the other locations to which you wish
to send the fax (maximum of 20).
•
To check your selected locations, press
delete a location, scroll to the location and then press
6
When you are ready to begin transmission, press
•
A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
locations are marked "Busy" or have a communication error code. If so,
send the document to those locations again.
36
to set the
RESOLUTION
/RECEPTION
(or ) until the name of the number appears in the display
to select the number.
to scroll through them. To
STOP
.
START/MEMORY
.