Sending A Fax From Memory - Sharp UX-B700 Operation Manual

Sending a Fax From Memory

Sending a Fax From Memory
You can scan a document into the fax's memory and send the document from
memory. This increases transmission speed and allows you to send a fax to
multiple destinations in a single operation. After transmission, the document is
automatically cleared from memory.
Note: If a power failure occurs while sending a fax from memory, you will need
to repeat the operation.
Broadcasting (sending a fax to multiple destinations)
This function allows you to send the same fax to as many as 20 different
destinations in just one operation.
♦
When sending to multiple destinations, only auto-dial numbers can be used
to dial the numbers of the receiving machines.
1
Load the document(s).
•
If desired, press
the resolution and/or contrast.
START/
2
MEMORY
Press
3
Select a destination using one of the following methods:
Press a Rapid Key.
Press
SPEED DIAL
Press
(if no name was stored, the number will appear).
50
RESOLUTION/
RECEPTION MODE
.
and enter a 2-digit Speed Dial number.
or until the name of the destination appears in the display
to set
READY TO SEND