Appendix- E-Mail Alert Function - Sharp AR-C200P Network Interface Manual

APPENDIX– E-MAIL ALERT FUNCTION
The following table explains how to set up the E-Mail Alert function via
Telnet.
7: Setup SMTP 1: SMTP Transmit
(E-Mail)
2: SMTP Receive
3: SMTP Server
Name
4: SMTP Port
Number
5: E-mail Address
6: Reply-To
Address
7: Destination
Address 1–
11: Destination
Address 5
1: To Address 1–5
2: Notify mode
3: Check time (hours) Set duration (1-24 hours) to
Appendix– E-Mail Alert Function 93
Set sending E-Mail via SMTP,
enabled or disabled.
Set receiving E-Mail via
SMTP, enabled or disabled.
Set IP address or host name
of SMTP server.
Set port number of SMTP.
Set the E-Mail address used
for [From] field in the mail
header.
Set the E-Mail address used
for [Reply-To] field in the mail
header.
Up to five E-Mail addresses to
which E-Mail alerts can be
sent.
Select how to notify
warnings/errors via E-
Mail.When any specified
status changes, E-Mail is sent
immediately if "EVENT" is
selected, or periodically if
"PERIOD" is selected.
send E-Mail when you select
"PERIOD" as Notify mode.