List Print; Key Operator Code Change; Product Key; Ps3 Expansion Kit - Sharp AR-M351N Key Operator's Manual

NOTES
G About stopped jobs
Printing of received faxes and Internet-Faxes and
transmission of stored fax jobs will automatically
resume after the machine restarts.
For jobs other than the above (copy jobs, print
jobs, document filing print jobs, etc.), the job
information is not retained and thus the stopped
job must be executed again manually (for
example, the original for a copy job must be
placed again and the copy operation repeated).
G Operation after optimization starts
Until optimization finishes (or the [CANCEL] key is
touched to cancel optimization),
• The operation panel cannot be used, with the
exception of the [CANCEL] key.
• Operation from the Web page is not possible.
• Faxes and Internet-Faxes cannot be received.
• Print jobs will not be accepted.
• The power will not turn off even if the power
switch is switched off.
• Auto power shut-off mode will not activate even
if the set time elapses. (Preheat mode will
activate.)

List print

This program is used to print lists and reports that can
only be printed from the key operator programs.
• Touch the [KEY OPERATOR PROGRAMS LISTS]
key to print one of the following groups:
Copy, printer, fax/image send, document filing,
general, security, all program lists
• Touch a key other than the [KEY OPERATOR
PROGRAMS LISTS] key to begin printing a list or
report.

Key operator code change

This program is used to change the key operator code
that must be entered to configure the key operator
programs. When the machine is first used, the key
operator should change the key operator code that was
set at the factory to the desired 5-digit code. Only one
key operator code can be programmed.
The factory default setting for the key operator code is
00000.

Product key

Use these programs to enter the product keys for the
following options.

PS3 expansion kit

This program is used to enter the product key for the
PS3 expansion kit (this allows the machine to be used
as a PostScript compatible printer).
Ask your dealer for the product key.

Network scanner expansion kit

This program is used to enter the product key for the
network scanner expansion kit.
Ask your dealer for the product key.

E-mail alert and status

This program is used to enter the product key for
E-MAIL ALERT AND STATUS, which enables
customer product support via a network system.
Ask your dealer for the product key.

Serial number

This program is used to check the serial number of the
machine.

Initialize and/or store settings

These programs are used to return the key operator
programs to the factory default settings, to store the
current key operator program settings, and to restore
stored key operator program settings. (Note that this
also includes printer configuration settings.)
The following programs are available:
G Restore factory defaults
G Store current configuration
G Restore configuration

Restore factory defaults

This program is used to return the key operator program
settings (including the printer configuration settings) to
the factory default settings. If you need a record of the
settings prior to restoration of the default settings, print
the key operator program list "List print" (page 13).
NOTE
After this program is set, exit the key operator
program, turn off the power switch, and then turn on
the power switch again after at least 3 seconds. The
program will be effective at this time.

Store current configuration

This program is used to return the key operator program
settings (including the printer configuration settings) to
the factory default settings. The stored settings will
remain in memory even if the power switch is turned off.
To read the stored settings, use the following "Restore
configuration" program.
*1

Restore configuration

This program is used to read the configuration that was
stored using the "Store current configuration" program
and restore it as the current configuration.
The currently set configuration will change to the
configuration read from memory.
NOTE
A confirmation message will appear at the end of the
setting procedure of programs marked by *1. If you need
to cancel execution of the program, touch the [NO] key.
GENERAL PROGRAMS
*1
*1
13