Sharp AR-C200P Network Interface Manual page 75

AIX 4.1.5 configuration
The following explanation uses AIX4.1.5 and a AR-C200P printer as
examples. The absolute path of commands and the method of
configuring may differ with the OS version. Refer to the workstation's
manual. If an incorrect IP address is entered, the network may go
down or other damage may occur. Configure after consulting the
network manager.
1. Log in as [root]. If you do not have superuser rights, the network
manager should conduct the configuration.
2. Register the IP address and the host name in the /etc/hosts file.
Example: for IP Address 192.168.29.127 and host name AR-C200P
192.168.20.127 AR-C200P
3. Use the ping command to confirm connection with the network
card.
Example: for host name AR-C200P
# ping AR-C200P
If there is no reply, there is a problem with the configuration of the IP
address (the IP address has already been set manually or
dynamically), or with the network. Reset the network interface card
settings to default and try to set a temporary IP address. If you still
have the problem after resetting the network interface card, consult
the network manager.
4. Register the host that was previously registered as the print
server.
Example: for the AR-C200P registered as the print server
a. Add the print server.
# ruser –a –p AR-C200P
b. Activate the remote printer daemon.
# startsrc –s lpd
# mkitab 'lpd:2:once:startsrc –s lpd'
UNIX 74