MATSONIC MS7102C Manual page 36

PM Control by APM
Windows 95 and 98 have built-in power management capabilities called APM
(advanced power management). When you enable this item, you allow the APM
routines in Windows to operate on your system.
Video Off Option
This option defines which level of power-saving mode is required in order to
power down the video display. As a default, the video powers down in suspend
mode but not standby mode.
Video Off Method
This item defines how the video is powered down to save power. As a default,
this is set to DPMS Support (display power management software).
Modem Use IRQ
If you would like an incoming call on a modem to automatically resume the
system from suspend mode, use this item to specify the interrupt request line
(IRQ) that is used by the modem.
Soft-Off by PWRBTN
Under ACPI (advanced configuration and power interface) the system can be
turned off mechanically (by the power button) or it can undergo a software power
off. If the system has been turned off by software, the system can be resumed by
a LAN, MODEM or ALARM wake up signal. This item allows you to define a
software power off using the power button. If the value is set to Instant-Off, the
power button will automatically cause a software power off. If the value is set to
Delay 4 Sec. the power button must be held down for a full four seconds to
cause a software power off.
HDD Power Down
You can use this item to set a timeout for a hard disk powerdown. You can set a
time from 1 to 15 minutes. If the hard disk is inactive for the time specified, it will
power down. It will automatically return to full power when it is next accessed.
Doze Mode
If you have selected User Define for the Power Management item, you can set
this item to a selection of timeouts from 20 seconds to 40 minutes.
Suspend Mode
If you have selected User Define for the Power Management item, you can set
this item to a selection of timeouts from 20 seconds to 40 minutes.
VGA
When this item is enabled, any activity on the graphics system can reset power-
saving mode timeouts to zero, or resume the system from a power saving mode.
LPT & COM
When this item is enabled, it defines system activities which can reset power-
saving mode timeouts to zero, or resume the system from a power saving mode.
This item is for transmissions through the serial or parallel ports.
Default: Yes
Default: Suspend -> Off
Default: DPMS Support
Default: 3
Default: Instant-Off
Default: Disabled
Default: Disabled
Default: Disabled
Default: OFF
Default: LPT/COM
33