MATSONIC MS7102C Manual page 23

Expansion Slots
You can use the expansion slots to install expansion boards that add
new features to your system. You must install a graphics adapter in
order to use the system.
1. The AGP slot can be used by a graphics adapter with an AGP edge
connector. This mainboard must be installed with a graphics adapter.
You do not need to use an AGP adapter. You can also install a
graphics adapter in a PCI slot or even an ISA slot.
2. If you have 32-bit PCI expansion cards, install them in on of the four
PCI slots. If you have 8/16-bit legacy ISA cards, you can install them
in one of the two ISA slots.
Note: The PCI slot PCI4 and the ISA slot ISA1 are shared slots.
This means that you can use either one of these slots, but not
both of them at the same time. The two slots correspond to the
same expansion card opening in the system case.
3. When you install an expansion card, remove the blanking plate from
the case expansion card opening that corresponds to the expansion
slot on the mainboard. Fit the bracket of the expansion card into the
expansion card opening and secure it in place with a screw.
20
AGP1
PCI1
PCI2
PCI3
PCI4
ISA1
ISA2