MATSONIC MS7102C Manual page 13

Installing a SLOT1 Cartridge Holder and Cartridge
The SLOT1 on the mainboard must be installed with a retention
mechanism to support the cartridge. The illustrations below show how to
install several different kinds of Slot1 cartridge holders.
Captive nut
Slot1
Locking
screw
Cartridge holder
This cartridge holder is in one
piece. Place the mainboard
on a plastic mat and then
secure the holder in place by
pushing the plastic pins
through the holder and
through the holes in the
mainboard.
Captive pin
Slot1
Foam
plastic
mat
10
Cartridge holder
This cartridge holder is in one
piece. The two upright posts may
be folded down for shipping.
Screw the captive nuts onto the
locking screws inserted in the
mainboard. Don't overtighten the
nuts as this will stress the
Cartridge holders
This cartridge holder is in two
pieces. Place the mainboard
on a plastic mat and then
secure the cartridge holders
in place by pushing the
captive pins through the holes
mainboard.
Pins
Slot1
Foam
plastic
mat
in the mainboard.