Table of Contents
Advertisement
WOL1/WOM1: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This en-
ables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically re-
sumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin
Signal Name
1
5VSB
2
Ground
3
SENSE
If you have installed a modem, use the cable provided with
the modem to plug into the mainboard WOM1 connector. This
enables the Wake On Modem (WOM) feature.
When your system is in a power-saving mode, any modem
signal automatically resumes the system. You must enable
this item using the Power Management page of the Setup
Utility. See Chapter 3 for more information.
IR1: Infrared data port connector
The mainboard supports an infrared data port. Infrared ports
allow the wireless exchange of information between your
computer and similarly equipped devices such as printers,
laptops, Personal Digital Assistants (PDAs), and other com-
puters.
Pin
Signal Name
1
NC
3
+5VDC
5
IR transmit
Pin
Signal Name
2
Key
4
Ground
6
IR receive
29
Advertisement
Table of Contents
