Table of Contents
Advertisement
Installing a CD-ROM/DVD Drive
1. Install the CD-ROM/DVD drive into the drive cage in
your Micro ATX system case.
2. Plug the IDE cable into IDE1 (A). If you have already
installed an HDD, use the other connector on the IDE
cable.
CD-ROM audio
connector
Colored
stripe
D
CDIN2
CDIN1
Note: The ribbon cable connectors are keyed so that they can only
be installed correctly on the device connector. If the connec-
tor is not keyed, make sure that you match the pin-1 side of
the cable connector with the pin-1 side of the device con-
nector. Each connector has the pin-1 side clearly marked.
The pin-1 side of each ribbon cable is always marked with a
colored stripe on the cable.
3. Plug an IDE cable connector into the CD-ROM/DVD
drive IDE connector (B). It doesn't matter which con-
nector on the cable you use.
4. Plug a power cable from the case power supply into
the power connector on the CD-ROM/DVD drive (C).
CD-ROM
B
A
Pin 1
24
C
Advertisement
Table of Contents
