Replacing The Lamp Socket; Software Installation - Martin MAC 700 WASH User Manual

Replacing the lamp socket

The lamp holder used in the MAC 700 Wash eventually wears out due to the high voltages that pass
through the contacts.
Wear begins to show up as discoloration at the contact surfaces. When this happens, resistance increases
and the lamp becomes harder to strike. If this process is allowed to continue, the lamp is likely to fail
prematurely.
Each time the lamp is replaced, inspect the lamp holder and have it replaced by a qualified technician as
soon as there are signs of discoloration or pitting at the contact surfaces. Damage caused by failure to
replace a worn and/or discolored lamp holder is not covered by the product warranty.

Software installation

Software updates are available from the Martin web site and can be installed via the data link with a Martin
upload device.
The following are required in order to install software.
• The MAC 700 Wash update file, available for download from the User Support Area of the Martin web site
(http://www.martin.com).
• The Martin Software Uploader program, version 5.0 or later, available for download from the User Support
Area of the Martin web site.
• A Martin MP-2 Uploader connected to a Windows 95/98/ME/2000/XP PC, or one of the PC controller
DMX interfaces supported by the Martin Software Uploader software.
T o in st al l so ftw ar e, n or mal meth od
Please refer to the MP-2 user manual and the Martin Software Uploader online help file.
T o in st al l so ftw ar e if all el se fails (boo t sector update)
Note: Use this procedure only if the firmware is totally corrupted, which is evident if the control panel does
not respond when power is applied, or if the software update notes call for a boot sector update. In the event
of a check sum error, repeat the normal upload procedure.
1. Disconnect the fixture from power.
2. Remove the side cover from the side of the base that has the control panel to expose the main PCB.
3. Locate the "BOOT" jumper on the main PCB (see page 33) and move the jumper cap to the "INIT"
position.
4. Perform a boot mode upload as described in the uploader documentation.
5. When the upload is complete, disconnect the fixture from power and move the jumper back to the
"DISABLE" position.
6. Reassemble the base.
22
#1
Figure 12: Air filter replacement
MAC 700 Wash