Component Video Out; Ntsc On Pal Tv - Pioneer DVR-320 Operating Instructions Manual

The Initial Setup menu
• The available settings depend on the Input Line
System setting (see Input Line System on page 74).
The table below shows the different options available.
Input Line System Built-in tuner
625 System PAL-N
525 System Auto
3.58 NTSC
PAL–M

Component Video Out

• Default setting: Interlace
You only need to make this setting if you connected this
recorder to your TV using the component video jacks.
Initial Setup
Basic Input Colour System
Tuner Component Video Out
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
If your TV is compatible with progressive-scan
component video, set this Progressive for the highest
quality picture. If your TV is not compatible with
progressive-scan video, leave it set to Interlace.
See also Progressive scan video in the glossary on
page 96.
External input
PAL-N
Auto
3.58 NTSC
PAL–M
Interlace
Progressive
Important
If you switch to Progressive when using a TV that is not
compatible with progressive-scan video, you will not be
able to see anything displayed on your TV. If this happens,
press and hold the + button on the front panel, then press
DISC HISTORY. This will set the recorder's video output
back to Interlace.
Compatibility of this unit with progressive-scan TVs
Consumers should note that not all high-definition television sets
are fully compatible with this product and may cause artifacts to
be displayed in the picture. In case of 525 progressive scan
picture problems, it is recommended that the user switch the
connection to the 'standard definition' output (Interlace). If there
are questions regarding our TV set compatibility with this model,
please contact our customer service center.
This recorder is compatible with the following Pioneer displays
and monitors
Plasma display
• PDP-505HD, PDP-5030HD, PDP-4330HD, PDP-5040HD, PDP-
4340HD, Pro-1000HD, Pro-800HD, Pro-1000HDI, Pro-800HDI, Pro-
1110HD, Pro-910HD, PDP-4300, PDP-5031, PDP-502MX
Projection monitor receiver
• SD-533HD5, SD-643HD5, Pro-710HD, Pro-610HD, Pro-510HD,
Pro-720HD, Pro-620HD, Pro-520HD, Pro-730HD, Pro-630HD, Pro-
530HD, Pro-730HDI, Pro-530HDI, Pro-700HD, SD-641HD5, SD-
582HD5, SD-532HD5

NTSC on PAL TV

• Default setting: Off
Initial Setup
Basic Input Colour System
Tuner Component Video
Video In/Out NTSC on PAL TV
Audio In
Audio Out
Language
Recording
Playback
When set to On, NTSC discs (from the U.S., for example)
will play correctly on a PAL-only TV. Change to Off if your
TV is already NTSC-compatible.
Depending on this setting and the Input Line System
setting (see Input Line System on page 74), the signal
format output when the recorder is stopped varies as
shown in the table below.
NTSC on PAL
Input Line System
TV
625 System Off
On
525 System Off
On
On
Off
Output when
stopped
PAL-N
PAL-N
NTSC
PAL–M
12
77
En