Other Settings You Can Make - Pioneer DVR-320 Operating Instructions Manual

04 Getting started
8 Is your TV compatible with progressive scan
video?
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
Use the (cursor up/down) buttons to select
Compatible, Not Compatible, or Don't Know, then
press ENTER.
• Note that progressive scan video is only output
through the component video outputs and only when
the video source is NTSC (see page 15).
9 Is this recorder connected to an AV amplifier/
receiver for digital audio?
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
Use the (cursor up/down) buttons to select
Connected, or Not Connected, then press ENTER.
• If you select Not Connected, that completes the
setup. Press ENTER to exit the Setup Navigator, or
select Go Back if you want to go back and start again.
• Select the digital audio formats your AV amplifier/
receiver is compatible with.
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
(cursor up/down) buttons to select Dolby
Use the
Digital, Dolby Digital, DTS or PCM only, then press
ENTER.
• Check the operating instructions that came with your
AV amplifier/receiver if you're not sure what it's
compatible with.
26
En
Progressive
Clock Set
Input Line System
On Screen Display
Compatible
Front Panel Display
Not Compatible
Remote Control SetSetup Navigator
Don't Know
Setup Navigator
Clock Set AV Amp Digital Connect
Input Line System
On Screen Display
Connected
Front Panel Display
Remote Control Set
Not Connected
Setup Navigator Setup Navigator
AV Amp Compatibility
Clock Set
Input Line System
On Screen Display
Dolby Digital
Front Panel Display
Remote Control Set Dolby Digital, DTS
Setup Navigator Setup Navigator
PCM only
10 Is your AV amplifier/receiver compatible with 96
kHz PCM digital audio?
Initial Setup
96kHz PCM Compatible
Basic Clock Set
Tuner Input Line System
Video In/Out
On Screen Display
Audio In
Front Panel Display
Audio Out
Remote Control Set
Language Setup Navigator Setup Navigator
Recording
Playback
Use the (cursor up/down) buttons to select
Compatible, Not Compatible, or Don't Know, then
press ENTER.
• Check the operating instructions that came with your
AV amplifier/receiver if you're not sure.
11 Press ENTER to exit the Setup Navigator, or select
'Go Back' if you want to start again.
Initial Setup
Basic Clock Set
Tuner Input Line System
Setup is complete!
Video In/Out On Screen Display
Enjoy using your DVD recorder!
Audio In Front Panel Display
Audio Out Remote Control Set
Language Setup Navigator Setup Navigator
Recording
Playback
That completes basic setup using the Setup Navigator.

Other settings you can make

After setting up using the Setup Navigator, you should be
ready to start enjoying your DVD recorder. It's possible,
however, that you may want to make a couple of
additional settings, depending on how the recorder is set
up for TV broadcasts.
• Manual channel setting – This setting lets you skip
channels where there is no station, as well as
manually tune to stations. See Manual CH Setting on
page 75.
• VCR plus+ channel setting – This setting lets you
assign guide channels to ensure that the VCR plus+
programming system works correctly. See VCR
Plus+ CH Setting on page 76.
• Setting up the remote to control your TV – You can set
up the supplied remote control to control many
brands of TV. See Setting up the remote to control your
TV on page 86.
Compatible
Not Compatible
Don't Know
Finish Setup
Go Back