Changing The Internet Settings; Parrot Audio Suite; Defining The Compensation Level For The Room; Using The Volume Ramp - Parrot ZIKMU SOLO User Manual

Note: Disabling the option does not change the settings in the Audio Effects menu.

Changing the Internet settings

You can change the Wi-Fi settings from the web interface. To do this:
1. Select Interface Settings >
2. Click Scan.
3. Select your Wi-Fi network.
4. Enter your WLAN security key in the
5. Click Apply.
> The green light on your Parrot Zikmu Solo flashes when the connection is in progress.
> The green light remains steady when the connection is established.
Enable/disable Wi-Fi by clicking Enable/Disable Wi-Fi.
If you want to change the IP address of your Parrot Zikmu Solo in particular to access it more easily from your smart phone:
1. Select Interface Settings > Wi-Fi > Fix
2. Enter your new IP address.
3. Click Apply.
Note: This option is only recommended for experienced users. If you select a fixed IP address, it must be on the same network as the
router. The router must also be configured to recognise and accept this fixed IP address.

Parrot Audio Suite

The Parrot Audio Suite lets you adjust the audio settings of the speaker and easily connect the speaker to your Wi-Fi network.
Your Smartphone must be connected to the Parrot Zikmu Solo via B luetooth or docked on the speaker if it is an iPod.

Defining the compensation level for the room

You can choose between 3 settings to make Parrot Zikmu Solo adapt its frequency to the position of your speaker within the
room. To do this, select the
You can also choose between the 5 predefined settings depending on the size of your room to obtain the best result.

Using the volume ramp

To avoid the risk of too high a volume when Parrot Zikmu Solo starts up, use the volume ramp. This option lets you define the
speed at which you want the Parrot Zikmu Solo to reach the volume set on the control bar.
To access this setting on the application, select the
You can enable or disable this option.
If this option is enabled, it will take about 20 seconds to reach the defined
volume.

Using the Bass Extender option

The option Bass Extender allows you to control the bass widening algorithm.
In order to improve the rendering of bass frequencies at low volume, this switch must be set to
ON. Otherwise, set it to off OFF.
Wi-Fi.
Key field if necessary.
IP.
Audio Effects menu then choose between Free,
Audio Effects
Wall and Corner.
menu.
23
Settings