Connection With An Rj45 Cable - Parrot ZIKMU SOLO User Manual

Warning: Make sure you do not mistake the WPS button with a pairing button. (ex : Livebox).
If your modem / router supports WPS technology:
1. Press the WPS button of your modem / router. Refer to the documentation of your device for more information.
2. Press the button of the Parrot Zikmu Solo, located behind the grid.
> The green light located next to this button blinks quickly when searching the WPS router.
> The green light blinks slowly when the router is found and the connection is awaiting the IP adress.
> The green light remains steady when the connection is established.

Connection with an RJ45 cable

Note: The RJ45 cable, also known as a network cable or Ethernet cable, is not supplied with the Parrot Zikmu Solo.
1. Connect your computer to the Parrot Zikmu Solo using an RJ45 cable.
> The white light blinks when the connection is in progress.
> The white light remains steady when the connection is established.
2. On your computer, open your web browser and enter http://zikmu-solo.local/wifi in the address bar.
> The list of available Wi-Fi networks will be displayed.
3. Click Scan and select your Wi-Fi network.
Note: The technical term used to denote the network name is SSID (Service Set Identifier). This can usually be found printed on the
underside of your router. If you have already changed the name of your Wi-Fi network, use the new name.
4. Enter the WEP / WPA / WPA2 key, if it is not greyed out, and then click Apply.
> The white light blinks when the connection is in progress.
> The white light remains steady when the connection is established.
Note: You will find the WEP, WPA or WPA2 key on the underside of your modem / router or in the documentation provided with
your system. If you have already changed the key for your wireless network, use the new key.
13
Wi-Fi