Technical Information; Installation Considerations - Hans Grohe Pharo Skyline 26017XX1 Installation Instructions / Warranty

Pharo Skyline Showerpanel
26017XX1

Technical Information

Recommended water pressure
Minimum water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Max. flow rate:
showerhead
handshower
neck spray
bodysprays
• Thermostatic temperature control
• The high temperature limit stop on the thermostatic mx-
ing valve may be reset to comply with local plumbing
codes.
• Protection against back siphonage provided by check
valves. The check valves should be removed and
inspected yearly.
• This panel may be used with an instantaneous water
heater if the heater is at least 24 kW and the output is
at least 3 gpm @ 30 psi pressure. However, only one
panel function may be used at a time.
*Please know and follow all applicable local plumbing codes when setting
the temperature on the water heater. In Massachusetts, the water heater
may be set no higher than 112�F.

Installation Considerations

• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• A minimum of two people is required to install
this panel. Do not attempt to install this panel
alone as injury or damage to the panel may result.
2
14.7 - 72.5 psi
29 psi
147 psi
120� - 140� F*
165�F*
2.5 gpm
2.5 gpm
2.5 gpm
0.72 gpm each
showerhead
neck spray
handshower
bodysprays
foot rest