Mitsubishi Electric M720 User Manual page 25

To enter text press the key bearing the required character until it appears in the display. Holding
the key displays the number corresponding to the key. If you need to use two characters from
the same key wait for a few seconds after typing the first character (until the key characters on
the upper part of the screen are cleared) or press the right arrow key before pressing the key
again.
Correct mistakes by a short press on Clear.
Holding the Clear key deletes all the text.
Use the left or right arrow keys to move the cursor in the text. Holding
special characters:
To select and insert a character into the text:
1
2
:
MULTITAP METHOD
Example To type Card:
Press OK and select
Select Write new.
Fill in the To field (see "sending a new sms message", page 26).
In the Text field press the down arrow key until
briefly three times, C is displayed.
Press
Press
Press
:
9
THE T
METHOD
A press on the down arrow key allows swapping between T9 text entry and the Multitap method.
1
Press the key bearing the required letter once only (the requested character may not be
displayed first).
2
The active word changes as you type. Type all the word characters up to the end of the word.
3 If the right word is not displayed when all the characters are entered press
the required word.
4
If the requested word does not belong to the displayed ones, press the down arrow key to
swap to the multitap method and type the correct letters in.
5
Use the left or right arrow keys to locate the cursor in the text to insert or delete characters.
Tips and Operation
KEY ACTION
Short press : to switch mode (T9 or multitap) to lower case, upper case or
numeric mode. Only the first letter typed is upper case, the following ones
are lower case (e.g.: to write a surname).
Long press : to switch from lower case to upper case.
Clear Clear or backspace
Short press: to enter a space.
Long press: gives access to special characters.
Another matching word
Smart punctuation
Short press: moves the cursor to each word beginning ( ) or end ( ).
Long press: moves the cursor to the text beginning ( ) or end ( ).
Swap between T9 and Multitap method
Move the cursor to the required character.
Select OK.
The symbol is only displayed when on SMS and MMS.
It allows to go to the following line.
Messages
until is displayed. Press
three times, r is displayed
once, d is displayed. The word Card is now displayed.
.
once, a is displayed
25- Messages
allows access to 25
is displayed. Press
until you get