Receiving A Message - Panasonic KX-TG8051FX Operating Instructions Manual

TG8051_8061FX(e-e).book Page 38 Monday, April 25, 2011 11:42 AM
SMS (Short Message Service)
5
To save the message, select "Yes". s
M
6
To send the message, press M.
L To cancel sending, press {ic}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS service
provider/telephone company. Contact your
SMS service provider/telephone company
for details.
L If your message contains over 160
characters, the message is a long message
and "@@Long Text@@" is displayed. Your
service provider/telephone company may
treat long messages differently from other
messages. Contact your service provider/
telephone company for details.
L If your phone is connected to a PBX, store
the PBX line access number (page 39).
Editing/sending a saved
message
1
1 (middle soft key) s e s M
2
{r}: "Send List" s M
3
To read a saved message, press {V} or
{^} to select the message. s M
4
To edit the message:
1 s {r}: "Edit Message" s M
s Continue from step 3, "Writing and
sending a new message", page 37.
To send the message:
1 s {r}: "Send" s M s Press
and hold ^ to erase all numbers. s
Continue from step 4, "Writing and
sending a new message", page 37.
Erasing saved messages
1
1 (middle soft key) s e s M
2
{r}: "Send List" s M
3
{r}: Select a message. s M
4
1 s {r}: "Erase" s M
L To erase all messages, select "Erase
All". s M
5
{r}: "Yes" s M s {ic}
38

Receiving a message

When an SMS message is received:
– "Receiving SMS Message" is displayed.
– a tone is heard (if the handset ringer is
turned on).
– e is displayed with the total number of
new (unread) SMS messages.
Reading a received message
1
1 (middle soft key) s e s M
2
{r}: "Receive List" s M
3
{r}: Select a message.
L Messages which have already been
read are indicated by a "Q", even if
they were read using another handset.
L To erase a message, press W. s
{r}: "Yes" s M
4
Press M to read the message content.
Note:
L To call the message sender, press {C}.
Replying to a message
1
While reading a received message, press
1.
2
{r}: "Reply" s M
3
Enter a message (page 47). s M
4
Edit the destination phone number if
necessary. s M
5
Continue from step 5, "Writing and
sending a new message", page 37.
Editing/forwarding a message
1
While reading a received message, press
1.
2
{r}: "Edit Message" s M
3
Continue from step 3, "Writing and
sending a new message", page 37.
Erasing received messages
1
While reading a received message, press
1.