Error Messages - Panasonic KX-TG8051FX Operating Instructions Manual

TG8051_8061FX(e-e).book Page 49 Monday, April 25, 2011 11:42 AM

Error messages

Display message Cause/solution
L The handset has lost communication with the base unit. Move
Base no power
or closer to the base unit and try again.
No link to base.
L Unplug the base unit's AC adaptor to reset the unit. Reconnect
Reconnect main
the adaptor and try again.
base AC adaptor.
L The handset's registration may have been cancelled. Re-register
or
the handset (page 33).
No link.
L When "No link." is displayed during a power failure, place a
handset on the base unit to supply power to the base unit.
L The supplied telephone line cord has not been connected yet or
Check Phone Line
not connected properly. Check the connections (page 10).
*1
L Recording was too short. Try again.
Error
L Phonebook copy failed (page 24). Confirm the other handset (the
Failed
receiver) is in standby mode and try again.
L The receiver's phonebook memory is full. Erase the unwanted
Incomplete
phonebook entries from the other handset (the receiver) and try
again.
L You tried to send an SMS message to a phone number saved in
Invalid Number
the phonebook, caller list, or redial list that is over 20 digits long.
L The phonebook memory is full. Erase unwanted entries (page
Memory Full
23).
L Message memory is full. Erase unwanted messages (page 41,
42).
L The call barred list memory is full. Erase unwanted entries (page
31).
L A wrong type of battery such as Alkaline or Manganese was
Use rechargeable
inserted. Use only the rechargeable Ni-MH batteries noted on
battery.
page 4, 7.
L You must subscribe to a Caller ID service. Once you receive
You must first
caller information after subscribing to a Caller ID service, this
subscribe to
message will not be displayed.
Caller ID.
*1 KX-TG8061
*1
Useful Information
49