Introduction; Levels Of Maintenance; How To Use This Manual - Minelab F1A4 Service Manual

1.

INTRODUCTION

This manual is intended to instruct service technicians in functional testing
and Level 1 maintenance of the F1A4 mine detector. All sub-assemblies of the
F1A4 can be replaced without the need for adjustment or calibration. This service
manual includes all Level 1 maintenance procedures, including functional testing and
troubleshooting.
1.1

LEVELS OF MAINTENANCE

Levels of maintenance for the F1A4 comprise:
Level 1:
Level 1 maintenance includes repair and/or replacement of all major
components of the detector. This level of maintenance can be conducted at
demining field sites or local depots if required. Level 1 maintenance includes full
functional testing of the detector and does not require any special test equipment or
facilities.
Level 2:
Level 2 maintenance encompasses Level 1 maintenance plus coil re-
termination and basic repairs to the F1A4 control box and earset. This level of
maintenance requires electronic workshop facilities.
Level 3:
Level 3 maintenance encompasses Level 1 and Level 2 maintenance,
plus control box printed circuit board repair. Level 3 repairs are only conducted at
Minelab's repair workshops located in Australia, Ireland and the USA.
1.2

HOW TO USE THIS MANUAL

This manual is divided into Level 1 maintenance sections. If doubt exists as
to the serviceability or mechanical integrity of the F1A4, turn to Section 2 for a
comprehensive mechanical and functional test of the F1A4. If any mechanical
component (eg handgrip, coil) of the F1A4 requires replacement, turn to Level 1
maintenance procedures in Section 3, which details all mechanical repairs. All
repairs to the F1A4 Control Box, and Coil retermination procedures require Level 2
Maintenance and should be sent to an accredited Level 2 repair facility.
F1A4 Field Service Manual – Level 1 Maintenance
Page 5