Viera Link; Network; To Reset This Unit - Panasonic Diga DMR-PWT500 Operating Instructions Manual

Troubleshooting guide

VIERA Link

VIERA Link does not work.
Some functions may not work depending on the
version of "HDAVI Control" of the connected
equipment. This unit supports "HDAVI Control 5"
functions.
If the connection for the equipment connected with
HDMI was changed, or if there was a power failure
or the plug was removed from the household
mains socket, "HDAVI Control" may not work.
In this case, change TV (VIERA) setting for
"HDAVI Control" again.

Network

You cannot access this unit from DLNA
compatible equipment on the network.
Check the network connection and the network
settings. ( 12, 15, 68, 83)
It may not be possible to connect depending on the
types of the equipment or the status of the
equipment.
When using Wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
Use 802.11n (2.4 GHz or 5 GHz) Wireless router.
Set the encryption mode on the Wireless router.
≥To check the encryption type of your wireless
connection ( 82, Wireless Settings)
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in connection
interruptions or other problems.
On the "Wireless Settings" screen (
continuous lighting of at least 4 "Reception"
indicators is the target for a stable connection. If 3
or fewer indicators are lit or the connection is being
interrupted, change the position or angle of your
Wireless router and see if the connection state
improves. If there is no improvement, connect to a
wired network and perform the "Network Easy
Setting" ( 15) again.
98
VQT3C81

To reset this unit

To return all the settings to the factory preset
Perform "Shipping Condition" or "Default Settings".
( 86)
To reset the PIN number for parental control
and the rating level settings
The PIN number for parental control and the rating
level return to the factory preset ("0000").
1 While the unit is on, press and hold [OK], the
"Yellow" button and the "Blue" button on the
remote control at the same time for more than
5 seconds.
–"00 RET" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control or [Í/I] on the main unit until "03 VL" is
displayed on the unit's display.
3 Press [OK] on the remote control or [< OPEN/
CLOSE] on the main unit.
–"INIT" is displayed on the unit's display.
82), the