Software (Firmware) Update - Panasonic Diga DMR-PWT500 Operating Instructions Manual

Software (Firmware) Update

Software of this unit can be updated automatically by
the following methods when this unit is in the standby
mode or when it is 3 a.m.
( 85, Software Update in Standby)
–From broadcasts
–From Internet
§
≥To update the Software (Firmware) immediately,
use the following function:
–Software Update Now ( Broadcast ) (
Software of this unit will be updated from
broadcasts if update information is detected.
–Software Update Now ( Internet )
Software of this unit will be updated from Internet if
update information is detected.
Network connection and setting are required.
§
( 12, 15)
∫ If a software (firmware) update is
available, a notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
≥Update of the software (firmware) will start when the
unit is turned to standby mode.
∫ The unit's display during the update
e.g.,
≥When "FINISH" is displayed, update of the
software (firmware) has completed.
You cannot operate the unit until the update is
85)
complete. Removing the AC mains lead while the
update is in progress may damage the unit. Don't
remove the AC mains lead during the update.
( 85)
§
≥ It may take up to a few hours until the update is completed
depending on the network or broadcast environment.
≥ If the timer recording is scheduled within the following time
at the start of the download, the download will not be
executed.
– From broadcast: Within 5 hours
– From Internet: Within 1 hour
≥ You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/
≥ If you do not want to perform the software (firmware)
update, set the "Software Update in Standby" to "Off".
( 85)
87
VQT3C81