Sound - Panasonic Diga DMR-PWT500 Operating Instructions Manual

The screen changes automatically.
If there is no operation for 5 minutes or more, the
displayed screen switches to the other states
automatically (only when the "Screen Saver" is set
to "On"). ( 79)
There is a lot of image lag when playing
video.
Set "HD optimizer" in the Picture menu to "Off".
( 71)
Set "Audio Delay". (
The images from this unit do not appear on
the TV.
The picture is distorted during play, or video
will not play correctly.
Check the connection and the TV's input settings.
An incorrect resolution is selected in "HDMI Video
Format". Reset the setting as follows:
1 While the unit is on, press and hold [OK], the
"Yellow" button and the "Blue" button on the
remote control at the same time for more than
5 seconds.
–"00 RET" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control or [Í/I] on the main unit until "04 PRG"
is displayed on the unit's display.
3 Press and hold [OK] on the remote control or
[< OPEN/CLOSE] on the main unit for at least
3 seconds.
Set the item again. (
–When Dolby Digital Plus, Dolby TrueHD, and
DTS-HD audio are not output in bitstream,
select "Yes" in "Default Settings" and make
proper settings. (
The unit's "TV System" setting differs from the TV
system used by the disc now playing. While
stopped, keep pressing [∫] (STOP) and
[< OPEN/CLOSE] on the main unit for 5 or more
seconds. The system switches from PAL to NTSC
or vice versa. ( 80)
Picture may not be seen when more than 4
devices are connected with HDMI cables.
Reduce the number of connected devices.
The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
DVD-R DL and +R DL discs have two writable
layers on one side. Video and audio may
momentarily cut out when the unit is switching
layers.
Set "Deep Colour Output" or "Contents Type Flag"
to "Off". ( 81)
79)
81)
86)
3D video is not output correctly.
Check the settings on this unit and the TV. (
When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video is
not output. ( 90)
When the amplifier/receiver which is connected
between this unit and a TV is off, 3D video is not
output. ( 90)
Discs that have recorded titles with Side by side
(2 screen structure) and that can be enjoyed in 3D
are played back in accordance with the settings of
the TV.
When "HDMI Audio Output" is set to "Off", 3D
video may not be output correctly. (
The same video is displayed in each left and
right half of the screen.
This is a 3D programme of the Side-by-Side type.
Change the setting as follows if connecting with a
3D compatible TV:
1 Press [OPTION].
2 Select "3D Settings", then press [OK].
3 Select "Side by side" in "Signal Format", then
press [OK].
TV reception is not displayed.
Broadcast signals are not output from this unit's
RF OUT terminal. Select "On" in "RF OUT ( Aerial
Signal )". ( 84)

Sound

No sound.
Distorted sound.
Check the connections or amplifier's settings.
( 10, 90)
Select the audio with "Multi Audio". (
To output audio from a device connected with an
HDMI cable, set "HDMI Audio Output" to "On".
( 81)
Cannot change audio channel.
You cannot change the audio channel if "Digital
Audio Output" is set to "Bitstream". (
47)
81)
27, 46)
79)
95
VQT3C81