Sending A Message - Panasonic KX-TCD820FX Operating Instructions Manual

TCD820FX(e-e).book Page 48 Tuesday, September 13, 2005 9:10 AM
SMS (Short Message Service)
k

Sending a message

Writing and sending a new
message
1
" (centre of joystick) i k i #
2
"Create" i #
L If "^Use Last Text?" is displayed,
you can use the text from the last
message you created by pushing the
joystick up.
3
Enter the message (page 61). i #
L j is displayed.
4
Enter the destination phone number (20
digits max.). i #
L Using the handset phonebook:
A i Select the handset
phonebook entry. i @
When only 1 phone number is
stored
#
When 2 or more phone numbers are
stored
Select the desired phone number. i
# 2 times
L Using the caller list:
Push the joystick up or down to select
the party. i # 2 times
L Using the redial list:
Press B repeatedly to select the
phone number. i # 2 times
5
To save the message, select "Yes". i
#
6
To send the message, press #.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
48
service provider. Consult your SMS
service provider for details.
L If your message contains over 160
characters, the message is divided into
multiple messages (up to 4), each
containing a maximum of 160 characters.
You can confirm how many messages are
required to send your text by the number
shown on the display ("1", "2", "3", or
"4"). The remaining number of characters
that can be entered is displayed next to
j. Your service provider may treat long
messages (messages over 160
characters long) differently from other
messages. Consult your service provider
for details.
L If your phone is connected to a PBX, store
the PBX line access number (page 50).
Sending a saved message
1
" (centre of joystick) i k i #
2
"Send List" i #
3
To read a saved message, push the
joystick up or down to select the
message. i #
4
To send the message, press ". i
"Send" i #
5
Press and hold {C/T} to erase all
numbers, then continue from step 4,
"Writing and sending a new message",
page 48.
Editing and sending a saved
message
1
" (centre of joystick) i k i #
2
"Send List" i #
3
Push the joystick up or down to select
the message. i #
4
" i "Edit Message" i #
i Continue from step 3, "Writing and
sending a new message", page 48.