Table of Contents
Advertisement
SMS (Short Message Service)
X
Registering mailboxes
Each SMS mailbox you wish to use must be
registered with BT Text. There are two ways
you can register a mailbox:
– Send an SMS message to another
person.
– Send the text message 'REGISTER' to
destination number 00000.
Sending a message
Writing and sending a new
message
1
" (middle soft key) i X i #
2
To access the public mailbox
"Public" i #
To access a private mailbox
Select the desired mailbox. i # i
Enter its password.
3
"Create" i #
L If "^Use Last Text?" is displayed,
you can use the text from the last
message you created by pressing {^}.
4
Enter the message (page 41). i #
5
Enter the destination phone number (20
digits max.). i #
L Using the handset phonebook:
H i Select the handset
phonebook entry. i # 2 times
L Using the caller list:
Press {^} or {V} to select the party.
i # 2 times
L Using the redial list:
Press B repeatedly to select the
phone number. i # 2 times
L If you wish to send the message to the
other party's mailbox, enter the other
28
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
party's mailbox number after the
destination phone number.
Example: The other party's phone
number is 123456 and their mailbox
number is 1.
Enter 1234561.
6
To save the message, select "Yes". i
#
7
To send the message, press #.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider/telephone company.
Consult your SMS service
provider/telephone company for details.
L If your message contains over 160
characters, the message is a long
message and j is displayed. Your
service provider/telephone company may
treat long messages differently from other
messages. Consult your service
provider/telephone company for details.
L If your phone is connected to a PBX, store
the PBX line access number (page 31).
Sending a saved message
1
" (middle soft key) i X i #
2
To access the public mailbox
"Public" i #
To access a private mailbox
Select the desired mailbox. i # i
Enter its password.
3
"Send List" i #
4
To read a saved message, press {^} or
{V} to select the message. i #
5
To send the message, press ". i
"Send" i #
6
Press and hold {C/T} to erase all
numbers, then continue from step 5,
Advertisement
Table of Contents
