Panasonic KX-TCD820FX Operating Instructions Manual page 67

TCD820FX(e-e).book Page 67 Tuesday, September 13, 2005 9:10 AM
Problem
The handset/base unit stops
working while being used.
Pressing B does not display/dial
the last number dialled.
Mute does not turn off after the line
is connected.
The handset beeps intermittently
and/or # flashes.
I fully charged the batteries, but #
still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to a
base unit.
Cause & solution
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Press {C/T}.
L Fully charge the batteries (page 13).
L Clean the charge contacts and charge again (page
13).
L It is time to replace the batteries (page 12).
L Consult your service provider.
L If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
L Do not pause for over 1 minute while searching.
L The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (page 58).
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 58).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Locate the handset and the base unit away from
other electrical appliances.
Useful Information
67