Download Print this page
Miele KM 411 Operating Instructions Manual

Miele KM 411 Operating Instructions Manual

Electric barbecue
Hide thumbs Also See for KM 411:

Advertisement

Operating Instructions
Electric Barbecue
KM 411
UV
To prevent accidents and
machine damage,
read these instructions
installation or use.
M.-Nr. 05 689 800

Advertisement

loading

Summary of Contents for Miele KM 411

  • Page 1 Operating Instructions Electric Barbecue KM 411 To prevent accidents and machine damage, read these instructions installation or use. M.-Nr. 05 689 800...
  • Page 2 ........3 .
  • Page 3 Please contact the nearest Before servicing, disconnect the Miele Dealer or the Miele Technical Ser- power supply by either removing vice Department with specific require- the fuse, unplugging the unit or manu- ments.
  • Page 4 In areas subject to infestation by cockroaches or other vermin, keep Do not use any type of aluminium the appliance and its surroundings products including pots, pans, and clean at all times. Any damage caused foil on the grill. Aluminium will cause by pests will not be covered under war- overheating and may damage the grill ranty.
  • Page 5 Extinguish flames immediately. The appliance becomes very hot when in use. Make sure that no one Replace the lava rocks regularly. comes in contact with it. The heating el- Rocks saturated with oil or fat ement and grate may be hot even catch fire easily.
  • Page 6 If in "tripping" the circuit breaker. doubt, select a longer cooking or re- Contact the Miele Technical Service De- heating time. partment. Do not use the appliance until it has Always cook pork thoroughly to en- been repaired.
  • Page 7 The cardboard box and packing materi- Old appliances contain materials that als are environmentally friendly for dis- can be recycled. Please contact your posal. Please recycle. local recycling center about the possi- bility of recycling these materials. Before discarding an old appliance, remove the power cord and any doors to prevent hazards.
  • Page 8 a Grate b Heating element (can be raised up) c Lava rocks d Lava rock container e Operating indicator lamp f Drain valve g Control knob h Water trough i Power cord...
  • Page 9 Metal components have a protective coating which may give off a slight odor the first time your new appliance is Before using for the first time clean the heated. water trough and the grate with a solu- The odor and any vapors will dissipate tion of hot water and liquid dish soap.
  • Page 10 ^ Reseat the lava rock container, if so desired. The grill can be used with or without ^ Lower the heating element and re- lava rocks. When cooking without lava rocks, rising steam will keep the food place the grate. moist.
  • Page 11 The grill can be turned on or off by turn- A safety cut-out switch prevents the ing the control knob either clockwise or heating element from turning on when it counterclockwise. is raised. The operating indicator lamp which is left of the control knob will illuminate when the appliance is switched on.
  • Page 12 ^ Preheat the grill by setting it to "12" and allowing it to run for approxi- mately 5 minutes. ^ Grill meat for a few minutes at the Sausages 6 - 8 highest setting to sear the outside and seal in the juices. Cutlets 10 - 12 ^ After searing, set the control knob to...
  • Page 13 ^ Turn off the grill. An overheating protection switch auto- matically turns off the appliance if the ^ Clean the grill after each use while it water level drops too low. is still warm (but, not hot)! See the ^ Add water to the trough. "Cleaning and care"...
  • Page 14 Under no circumstances use a Ceramic surfaces can be cleaned with steam cleaner to clean this appli- a damp cloth. ance. Pressurized steam could cause permanent damage to the Wipe dry using a soft cloth. surface and to components for Do not use too much water when which the manufacturer cannot ac- cleaning the controls.
  • Page 15 ^ Remove or wipe clean any residues remaining in the reservoir. The heat- ^ Let the water cool to a safe temper- ing element can be raised to make ature to prevent burns. this easier. ^ Place a container of a suitable size (a ^ Fill the water trough with a mild solu- metal pot for example) under the tion of liquid dish soap and warm wa-...
  • Page 16 Add water to the trough. Refer to section "Overheating protec- tion". – the electrical circuit has blown a fuse or "tripped" the circuit breaker. If power cannot be restored, it may be necessary to call either an electrician or the Miele Technical Service Dept.
  • Page 17 All electrical work should be per- formed by a qualified electrician in accordance with local and national The appliance is provided with 3 leads; codes. L1 (black), L2 (red) and GND (green). They must be connected to a dedi- cated line through the use of an ap- Disconnect the appliance from the proved junction box.
  • Page 18 In the event of a fault which you cannot correct yourself contact: – Your Miele Dealer – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate.
  • Page 20 Alteration rights reserved 00/0202 This paper is made from cellulose bleached without the use of chlorine.