Table of Contents
Advertisement
TCD340FX(e).book Page 66 Wednesday, June 8, 2005 3:57 PM
Useful Information
Problem
Noise is heard during a call.
The handset/base unit stops
working while being used.
While storing an entry in the
phonebook or assigning a one
touch dial, the handset starts to
ring.
Pressing q/ {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 3 flashes.
I fully charged the batteries, but
3 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot set call restriction.
I cannot register a handset to a
base unit.
66
Cause & solution
L You are using the handset or base unit in an area
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L A call is being received. To answer the call, press
{C}. Programming will be cancelled. Start again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 12).
L Clean the charge contact and charge again (page
12).
L It is time to replace the batteries (page 14).
L Consult your service provider.
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L Do not pause for over 1 minute while searching.
L Call restriction can be set using handset 1 only. If
you have multiple handsets, you can confirm which
handset is handset 1 by pressing {x} and {1} on
the base unit. Handset 1 will start ringing.
L The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (page 56).
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 56).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Locate the handset and the base unit away from
other electrical appliances.
Advertisement
Table of Contents
