Konica Minolta BIZHUB 350 User Manual page 402

Specifying management settings
4
Specify the mode setting using either bit selection or HEX selection.
– To specify in bit values, touch [Bit Selection], touch [←] or [→] to
move the cursor to the bit to be changed, type in the value using
the keypad, and then touch [Enter].
Soft SW Setting
Mode Selection
Bit Selection
HEX Selection
– To specify in hexadecimal values, touch [HEX Selection], specify
the value by using the keypad and touching [A]—[F], and then touch
[Enter].
Soft SW Setting
Mode Selection
Bit Selection
HEX Selection
5
To change the settings for other modes, repeat steps 3 and 4.
6
Touch [Enter] until the initial screen appears.
7
Turn the machine off, then on again.
Reminder
When turning the machine off, then on again, wait about 10 seconds after
turning the machine off before turning the machine on again. The settings
may not be applied correctly if the machine is turned on immediately after
it is turned off.
200/250/350
Enter
000
00110000
76543210
30
A
B C
D
E F
000
00110000
76543210
30
A B C
D E F
Memory
Free
Set
Enter
Set
100%
9
9-33