Table of Contents
Advertisement
Setting up the printer driver
6
To apply the settings, restart this machine (turn it off, then on again).
–
When turning the machine off, then on again, wait at least 10
seconds to turn the machine on after turning it off. The machine
may not operate correctly if it is turned on immediately after being
turned off.
Turn this machine back on to apply the IP address.
Note
The network settings should be specified according to instructions from
the network administrator.
A password is required in order to enter Administrator mode. Contact the
administrator for the administrator password.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible that the IP address
automatically be assigned by the DHCP server. When "IP def. method" is
set to "Auto Input" and "DHCP Setting" is set to "Enable", the IP address,
subnet mask and default gateway are automatically assigned by the
DHCP server on the network, so it is not necessary to assign them
manually. However, consider the following when setting "DHCP Setting"
to "Enable".
Consult with the network administrator to check that a DHCP server
exists. If a DHCP server does not exist, be sure to specify settings for "IP
Address", "Subnet Mask" and "Default Gateway".
If the IP address and other settings have been assigned by the DHCP
server, they may automatically be changed. If the IP address and other
settings are changed and a printer on the network has been specified by
its IP address for printing, printing may not be possible since this
machine cannot communicate with the network.
If "DHCP Setting" has been set to "Enable", it is recommended that a
fixed IP address be assigned to this machine in the DCHP server settings.
bizhub C252P
3
3-37
Advertisement
Table of Contents
Troubleshooting
