Messages
Unit displays (in general)
H∑∑ or F7∑∑
(∑∑ stands for a number.)
NO DISC
NO PLAY
OVER CURRENT ERROR
U11
U59
U70-∑
(∑ stands for a number.)
H19, F61 or F76
100
≥Trouble may have occurred. The number following "H" and "F7" depends
on the status of the unit. Turn the unit off and then back to ON.
Alternatively, turn the unit off, disconnect the AC mains lead, and then
reconnect it.
≥If the service numbers fail to clear, note the service number and contact a
qualified service person.
≥You haven't inserted a disc: Insert one.
≥You haven't inserted the disc correctly: Insert it correctly.
≥You inserted a disc the unit cannot play: Insert one it can.
≥You inserted a blank disc.
≥You inserted a disc that has not been finalized.
≥The USB device is drawing too much power. Switch the selector to "DVD/
CD", remove the USB and turn the unit off.
≥The disc may be dirty.
≥The temperature inside the unit has risen, and operation has stopped for
safety purposes. Wait about 30 minutes until the message has
disappeared before using the unit again. Place the unit in an area with
good airflow and make sure that the ventilation openings are not blocked.
≥The HDMI connection acts unusually. The actual number following "U70-"
will depend on the state of this unit.
–The connected equipment is not HDMI compatible.
–The HDMI cable is too long.
–The HDMI cable is damaged.
≥Trouble may have occurred. Turn the unit off and on. When the message
still appears, disconnect the AC mains lead and consult your dealer.
Page
—
—
—
11
20
—
20
—
19
—
—
—