Backing Up Data Recorded To The Hdd - Panasonic SC-PTX7 Operating Instructions Manual

Backing up HDD data to a PC

Backing up data recorded to the HDD

Cautions about backup data:
Be careful not to perform any of the following:
≥Do not open backup data with applications or
software, and do not change the contents.
≥Do not compress the backup data.
≥Do not change the backup data file name or
change the saved location.
Perform "Preparation" and "Settings to check on the PC"
as described on page 81.
1
Press [SETUP].
2
Press [3 4] to select "Other Setup" and press
[ENTER].
3
Press [3 4] to select "Maintenance" and press
[1].
4
Press [3 4] to select "Backup/Restore" and
press [ENTER].
5
Press [3 4] to select "Backup" and press
[ENTER].
6
Press [3 4] to select "PC Name" and press
[ENTER].
When the PC name is displayed
The PC name and other information that was used
when previous backups and imports (➜ page 44)
were performed may be displayed. In this case,
check the PC name again, and if necessary, follow
the steps below to make changes.
7
Enter the characters (➜ page 62).
Input the "User Name" and "Password" in steps 6
and 7 in the same manner.
8
Press [3 4 2 1] to select "Backup" and press
[ENTER].
Backup begins.
A message will be displayed, indicating that backup
is complete. The unit will briefly stay this way, and
then it will turn off automatically shortly after.
To return to the previous screen
Press [RETURN].
82
Backup
PC Name
User Name
Password
Backup Cancel
ENTER
Cancel
To cancel backup
1 Press and hold [Í] during backup.
2 Press [2 1] to select "Yes" and press [ENTER].
≥This unit turns off and backup cancelled.
To continue a previously cancelled backup
1 After backup is cancelled, press [Í] to turn the unit
on again.
The following message is displayed.
2 Press [2 1] and select "Yes", then press [ENTER].
Follow the steps given on screen, and start backup
again.
NOTE
≥When the backup is cancelled partway through,
the data becomes unusable. Finish the backup as
soon as possible.
≥The settings for the Power Off Mode for this unit
will enter "Power-Save Mode" (➜ page 88) until
the backup is complete.
≥When performing a backup, all timer settings will
be set to "Off". If you use a timer, you will need to
set to "On" again (➜ page 79).
If the backup aborted due to critical errors or
abnormal termination
After the message is displayed on the unit, this unit
will automatically turn off.
In this situation, turn the power on again and
continue the backup.
A note about the second (and subsequent)
backups
Only newly added tracks and changes made since
the previous backup was created will be backed up,
therefore the backup will take less time to finish
than the first time.
Backup
This function will pause and the power will turn off
immediately.
Do you want to continue?
Yes No
ENTER
Incomplete Backup
Backup is incomplete.
Do you want to resume Backup?
Yes No
ENTER