Scan Stand Symbol; Presentation Mode; Presentation Led Behavior After Decode - Hand Held Products 4600g User Manual

Scan Stand Symbol

When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand symbol
on the base of the stand which tells it to remain idle. When the Scan Stand
symbol is covered, the imager turns the LEDs on at the configured power level
(Default High) and attempts to find and decode bar codes in its field of view.
Scan Stand Symbol

Presentation Mode

This programs the imager to work in Presentation mode. The LEDs are either off
or at the lowest power for ambient conditions until a bar code is presented to the
imager. Then the LEDs turn on automatically to read the code. Presentation
Mode uses ambient light to detect the bar codes. If the light level in the room is
not high enough, Presentation Mode may not work properly.
Presentation Mode

Presentation LED Behavior after Decode

When an imager is in presentation mode, the LEDs remain on and continue
scanning for a short time after a bar code is decoded. If you wish to turn the
LEDs off immediately after a bar code is decoded, scan the LEDs Off bar code,
below. Default = LEDs On.
* LEDs On
LEDs Off
3 - 6 4600g, 4600r, 4800i User's Guide