Scan Stand Mode - Hand Held Products 4600g User Manual

Note: Manual Trigger, Low Power cannot be used with keyboard wedge
applications.
Low Power Time-Out Timer
Scan the Low Power Time-Out bar code to change the time-out duration (in
seconds). Then scan the time-out duration (from 0-300 seconds) from the inside
back cover, and Save . Default = 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into
low power mode. Whenever the trigger is enabled, the low power time-out timer
is reset.
Note: This time-out does not begin until the imager time-out setting has expired.

Scan Stand Mode

When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan
Stand symbol. (See
presented, the imager is triggered to read the new code.
Note: The imager automatically adjusts the illumination LEDs to the lowest light
level possible to maintain a good lock on the Scan Stand symbol. When
a symbol is presented, the imager's light levels adjust to the saved setting
(see LED Power Level
of ambient light to operate correctly.
4600g, 4600r, 4800i User's Guide
Low Power Time-Out
Scan Stand Symbol
on page 3-9). This mode requires at least 50 lux
Scan Stand Mode
on page 3-6.) When a different code is
3 - 5