Recharging The Collar Battery - D.T.Systems BTB 800 Owner's Manual

The BTB 809 has Two Operating Modes. Run/Point and
Point only. When the unit is first turned on it is
automatically set to Run/Point mode. To switch to Point
only mode quickly depress the Power and Mode Selector
Switch (less than one second). The LED indicator light will
blink once and then resume blinking once every two seconds.

RECHARGING THE COLLAR BATTERY

The LED Indicator Light will let you know when the battery
needs charging by changing from the regular two second
blink to a rapid blink (twice per second).
NOTE: If the batteries have been allowed to
completely run down then the light will not blink at all.
To charge the battery, plug the charger into the battery
receptacle on the collar and plug the adapter into any
standard 110 Volt household wall outlet. (A 220 Volt
European adapter is available from D.T. Systems).
Recharge the battery for no more than 14 hours.
Important: After charging make sure to plug in the rubber
receptacle plug firmly to prevent dirt and water from
entering the unit.
7