Btb 800 Operation - D.T.Systems BTB 800 Owner's Manual

BTB 800 OPERATION

Turning the unit ON:
To turn the BTB 800 ON, depress the Power and Mode
Selector Switch for approximately two seconds. (When
you press the switch the LED indicator will light for
two seconds. As soon as the light goes out you may let
go of the switch). The unit is now ON. The LED light
will blink once every two seconds.
Turning the unit OFF:
Turning the BTB 800 OFF works the same way as
turning it on, depress the Power and Mode Selector
Switch for approximately two seconds. (When you
press the switch the LED indicator will light for two
seconds. As soon as the light goes out you may let go
of the switch). The unit is now OFF.
The BTB 800 has Two Operating Modes. Run/Point
and Point only. When the unit is first turned on it is
automatically set to Run/Point mode. To switch to
Point only mode quickly depress the Power and Mode
Selector Switch (less than one second). The LED
indicator light will blink once and then resume blinking
once every two seconds.
5