Mounting The Quadcharger - Hand Held Products DOLPHIN 7600 User Manual

Mounting the QuadCharger

The QuadCharger should be mounted on a dry, stable surface such as a desktop or workbench, or a flat, vertical surface such
as a wall.
Mounting Location
When choosing a location for the QuadCharger:
• Keep in mind that the mounting location must allow users easy access to power switch and power connector.
• Do NOT place the QuadCharger in an enclosed space because restricted air flow can cause the temperature to elevate, which
can effect charging. For more information, see
Mounting Process
To mount the QuadCharger, slide the DIN Rail into the slot on the bottom panel. Then, using the appropriate nuts and bolts,
secure the DIN rail to the desk or wall.
Bottom Panel Mounting Dimensions
4.78 in.
(121.4
mm.)
1.42 in.
1.17 in.
(36 mm.)
(29.7 mm.)
DIN Rail Dimensions
.98 in. (25 mm.)
Mounting Guidelines
1. Before you begin, make sure you have two screws that are size #5–diameter measurement of 0.125 in. (3.18 mm).
2. Drill two holes into the wall, using the slots of the DIN Rail to locate. To ensure stability, holes should be located at least 4
inches (101.6mm) apart.
3. Insert a screw into each hole. The screw heads should be flush with the surface of the DIN rail,
9 - 4
Battery Charging
11 in. (278.93 mm.)
.99 in.
.13 in. (3.4 mm.)
(25.2 mm.)
.7 in. (17.8 mm.)
.25 in.
1.38 in.
(6.3
(35 mm.)
mm.)
Rev D
10/18/2007
on page 9-3.
6.17 in. (156.8 mm.)
1 in.
(27mm.)
.99 in. (25.2 mm.)
.14 in.
(3.6 mm.)
.04 in. (1 mm.)
Dolphin® 7600 User's Guide