Pre-Installation Assembly - HAMPTON BAY H300 Owners & Installation Manual

INSTALLATION
PRE-INSTALLATION
ASSEMBLY
After removing the stove from its packing, open
the front door and remove the contents from the
fi rebox, leaving the bricks in place.
Draft Control
Lever Handle
1) Insert bolt and lock washer through draft
control lever hole.
2) Place handle through bolt. Tighten to se-
cure.
Handle
Washer
Draft Control Lever
6
Rotating Elbow
This stove can be connected to either a top or
rear vent exit by simply reversing the orientation
of the elbow.
Simply remove the 2 screws, change the posi-
tion of the elbow as desired and secure in place
with screws.
Rear Heat Shield
1) Loosen the bolts that secure the elbow to
the unit. Ensure elbow does not fall off.
2) Bend the tabs on the rear heat shield inwards
90 degrees.
Bolt
Bend tabs inwards 90 degrees.
3) Slide the tabs on the rear heat shield in
between the bolt and washer.
Please Note: The shield needs to be stretched/
fl exed in order to fi t in place.
Slide tabs in between
washer and bolt.
4) Once rear heat shield is evenly in place,
tighten bolts to secure.
1) To install side door handle, remove side
door plug assembly.
Hex Nuts
2) Assemble handle by:
a) Placing lock washer over hex head bolt.
b) Place hex head bolt into handle.
c) Place spacer over hex head bolt
threads.
d) Screw handle into side door latch.
3) Place side door handle latch through side
door hole.
4) Re-assemble side door plug assembly to
secure.
Side Door
Plug Assembly
Rear Heat Shield
Hampton H300 Cast Freestanding Woodstove
Side Load
Door Handle
Side Door Plug Assembly
Door Latch Bar
Side Door
Plug
Flat Washers
Latch
Spacer
Handle
Hex Head
Lock
Bolt
Washer
Latch