Comtrend Corporation CT-536+ User Manual page 61

The screen creates a traffic class rule to classify the upstream traffic, assign queuing
priority and optionally overwrite the IP header TOS byte. A rule consists of a class
name and at least one condition below. All of the specified conditions in this
classification rule must be satisfied for the rule to take effect. Click 'Save/Apply' to
save and activate the rule.
Traffic Class Name
Assign ATM Transmit Priority
Mark IP Precedence
Mark IP Type Of Service
Mark 802.1p if 802.1q is
enabled on WAN
Specify Traffic Classification Rules
Enter the following conditions either for physical LAN/Wireless port or for IP level,
SET-1, or for IEEE 802.1p, SET-2
Enter name for traffic class.
Select Low, Medium or High.
Select between 0-7. The lower the digit shows the
higher the priority
If non-blank value is selected for 'Mark IP
Precedence' and/or 'Mark IP Type Of Service', the
corresponding TOS byte in the IP header of the
upstream packet is overwritten by the selected
value.
Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
Select either: Normal Service, Minimize Cost,
Maximize Reliability, Maximize Throughput,
Minimize Delay
If non-blank value is selected for 'Mark IP
Precedence' and/or 'Mark IP Type Of Service', the
corresponding TOS byte in the IP header of the
upstream packet is overwritten by the selected
value.
Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
Select between 0-7.
60