Installing The Usb Driver - Comtrend Corporation CT-536+ User Manual

Connection to Power
Connect the Power jack to the shipped power cord. Attach the power adapter to
the wall outlet or other AC source.
After all connections have been made, turn the power-switch to the on position.
After power on, the router performs a self-test. Wait for a few seconds until the test
is finished, then the router will be ready to operate.
Caution 1: If the router fails to power up, or it malfunctions, first verify that the
power supply is connected correctly. Then power it on again. If the
problem persists, contact our technical support engineers.
Caution 2: Before servicing or disassembling this equipment always disconnect all
power cords and telephone lines from the wall outlet.
2.2

Installing the USB Driver

Before you connect your router's USB cable to your PC, you must load the ADSL USB
drivers. The USB driver supports Windows 98, ME, 2000, and XP.
To connect the router to a PC using the USB interface, you need to use a standard
USB cable and install the USB interface software. Follow the steps below:
STEP 1: Connect the USB router to the PC by plugging the flat connector of a
standard USB cable into your PC, and plugging the square connector into
the router. The screen will display as below:
9