Preset Download - JVC HR-S6855EK Instructions Manual

before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Be sure to use the fully-
wired 21-pin SCART cable
Turn on the TV whose
channels have already
been stored
– –:– –
O
TV
TV/VCR AUDIO – –:– –
1 2 3
. , / ABC DEF
2
4 5 6
GHI JKL MNO
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
PQRS TUV WXYZ
0000 AUX 4
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
PROG ? 30 SEC
1
TE PR
FINISH AUTO SETUP
Press O and move on to
If there is a power cut or you accidentally press a button during
oops!
, turn the VCR off and then on again. Re-perform
Setup

Preset Download

START PRESET DOWNLOAD
Press the o button. The display panel on the
front of the VCR will show the word 'Auto'.
Press the A or B buttons to select
'CH – –' and press O (or E).
what will happen?
cally setting up the tuner channels by down-
loading from your TV, clock and the VIDEO
Plus+ assigned Guide Program numbers.
During downloading, preset position on the
display panel increases from "CH1".
rf and scart connection
manual), you will see the following information displayed on your TV screen:
T-V LINK
PLEASE WAIT
[MENU]: EXIT
SET THE VIDEO CHANNEL TO OFF
When
Preset Download
PLETED' appears on the TV screen. Press o to
turn off the VCR. Press and hold down S on the
VCR until you will see the display on the right.
Press Button on the Remote Control until the
PR
figure reads '– –'.
FINISH PRESET DOWNLOAD
Press O and move on to
If there is a power cut or you accidentally press a button during
oops!
, turn the VCR off and then on again. Re-perform
Download
NOTES
• In areas where no TV station transmits the PDC signal, the VCR cannot setup
either the clock or Guide Program numbers.
• On this VCR, the characters available for station names (ID) are A–Z, 0–9, –,
*
, + and (space). The names of some downloaded stations may differ from
those on your TV.
three step quick start
to check the results.
Step 2
The VCR is automati-
If the TV set is in its AV mode (see the TV
GUIDE PROG SET
PLEASE WAIT
[MENU]: EXIT
has finished, 'COM-
to check the results.
Step 2
Auto
.
Auto Setup
Preset Download is running:
don't touch any buttons
Your TV screen during Preset
Download
Preset
Preset Download
11
.